INSTRUCTIONS

1.
 finding the puncture FINDING THE PUNCTURE.
Following directions for Leak Seeker, locate leak.
2.
 reamer tool cleaning puncture FINDING DIRECTION
AND CLEANING THE PUNCTURE.
Using Reamer Tool, gentle push into puncture to find dire tion of injury. Then move reamer in and out to clean hole.
3.

THREADING NEEDLE
Thread approximately 6" of patented PSP Material thru eye of Injector Tool until ends are even. (Larger repairs may require 2 strands.)
4.
 apply bonding compound APPLYING BONDING COMPOUND
Holding both sides of material against needlle, dip into Bonding Compound about 1"
5.
 insert puncture INSERT INTO PUNCTURE
Push Injector Tool into injury following direction of puncture with steady pressure leaving 1" of material exposed.
6.

TWIST TOOL AND WITHDRAW
Twist Injector Tool 1/4 turn clockwise. This ensures good seal. Then, with a steady pull, withdraw tool until end is 1" outside of tire. For larger punctures, repeat steps 3 thru 6 until injury feels tight. DO NOT OVERPACK.
7.
 check for leaks CHECK FOR LEAKS
Inflate tire to proper inflation, check repair with Leak Seeker solution.
8.
 trim excess material from tire TRIM EXCESS MATERIAL
After testing cut off excess material 1/4" from tire.
 
email